Full-automatic wet towel packaging machine manufacturer: What is the basic maintenance process of the packaging machine

Automatic Wet Wipes Packaging Machine Factory: Basic Maintenance Process of Packaging Machine

Fully automatic wet towel packaging machine manufacturer: Before working every day, the conveyor belt of the machine should be cleaned by air pressure.

Automatic Wet Wipes Packaging Machine Factory: Maintenance of Remaining Recovery Shaft

(1) maintenance once a month.

(2) Remove the fixing nut of the recovery wheel, and take out the spring and the collection wheel.

(3) Coat the contact surface between the shaft center and the collecting wheel with butter to keep the collecting wheel running smoothly.

Automatic Wet Wipe Packaging Machine Manufacturer: When shrink film residue is found on the sealing edge, please gently remove the surface residue with a cork board. It is forbidden to wipe with metal. Metal friction will destroy the protective film on the knife and reduce the function of the sealing knife.

Automatic wet towel packaging machine manufacturer: maintenance of bearings and bearing seats: maintenance should be carried out every three months. Parts with bearings and bearing seats on the outer surface of the machine should be lubricated by hydraulic oil dripping into the contact gap between the bearing and the main shaft, and the surface of the machine should be kept clean.

Full-automatic wet towel packaging machine manufacturer: maintenance of chain and sprocket: about once every three months, first remove the protective cover of the transmission part, apply butter to the contact gap between the chain and sprocket, and then replace the protective cover after maintenance.

Fully automatic wet towel packaging machine manufacturer: adjust the belt tightness: after the belt runs for a period of time, the belt will relax. If the belt drive is not tight, you need to adjust the belt tightness.

Fully automatic wet towel packaging machine manufacturer: check whether the cutting knife fixing screw is locked, if loose, lock. (once a month)

Automatic Wet Wipes Packaging Machine Factory: Check the Teflon tape on the sealed silicone tape. If it is damaged, it needs to be replaced.

Full-automatic wet towel packaging machine manufacturer: If the Teflon on the cutting knife has fallen off and the adhesive film is easy to stick to the cutting knife, the cutting knife should be treated with Teflon again or replaced with a new sealing knife.

Automatic Wet Wipes Packaging Machine Manufacturer: Electric Heating Tube Replacement: When the electric heating tube cannot be heated, it should be replaced.

(1) before replacing the electric heating tube, it is necessary to determine whether the voltage and wattage of the electric heating tube meet the requirements, and then turn off the power supply until the waste heat of the electric heating tube is eliminated.

(2) Remove the wires of the electric heating tube in the junction box.

(3) Loosen the fixing screws of the electric heating tube, take out the electric heating tube, and then put the newly purchased electric heating tube in.

(4) Ensure that all screws are fixed and locked, and lock the junction box after connecting all lines.

Fully automatic wet towel packaging machine manufacturers: lifting screws should be well lubricated: should be maintained about once a month. First, remove the outer baffle and lubricate the contact gap between the T-screw and the T-nut. Then, turn the adjusting handle to adjust the lifting device up and down to fully lubricate the lubricating oil. After maintenance, install the outer baffle.

Automatic Wet Wipe Packaging Machine Manufacturer: Replacement of heat-resistant rubber or heat-resistant tape:

(1) After the residual temperature of the electric heating tube is eliminated, turn off the power and tear off the heat-resistant tape.

(2) Take out the heat-resistant rubber, replace the newly purchased heat-resistant rubber, and cooperate with the concave installation of the tool holder to ensure that the surface is completely flat, and remove the excessively long and redundant parts.

(3) Paste the heat-resistant tape again, and pay attention to the tape should be flat without wrinkles.

These are the matters needing attention in the maintenance of the packaging machine. If you want to know more about the product details of the packaging machine, please consult us.