Three side seal wipes packaging machine use matters needing attention

After more than 20 years of development, China's packaging machinery has become one of the main industries in the machinery industry, providing a strong guarantee for the rapid development of China's packaging industry. Some packaging machines fill the gap in the market and basically meet the needs of the domestic market, and some products can be exported. But at this stage, China's export value of packaging machinery is less than 5% of the total output value, and the import value is basically the same as the total output value, which is far from the developed countries. In the process of rapid growth of the machinery industry, mechanical failures will inevitably occur, and the general failures and maintenance methods of the three-sided wet towel packaging machine will be avoided.

1. The speed of the three-side sealing wipes packaging machine is too fast, the heat sealing property of the inner layer of the coating becomes worse, and the seal leaks or is unstable when the temperature is too low. The repair method is to slow down, increase the temperature, and change the material of the film.

2. The solid circuit breaker of the three-side sealing wet towel packaging machine was burned, the temperature meter was damaged, and the thermocouple was damaged. The temperature meter could not adjust the temperature. The maintenance method is to replace the coupling, the temperature meter and the heating element.

3. The color code of the film is too light, the film is driven to slide, the color code tracking cannot be opened, and the cutting position deviates from the color code. At this time, the maintenance method is to adjust the sensitivity with reference to the packaging instructions. In the human-computer interaction interface, the tracking mode is switched to the tracking switch.

4. When the tool holder is too high or too low, the packaging speed is too fast, the push rod and the tool are not in synchronization, the tool is cut by the product. The maintenance method is to reduce the packaging speed and adjust the height of the end sealing part so that the center of the sealing blade is in the middle of the product height.

5. When the temperature of the three-sided sealing wipes packaging machine is too high, the speed is too slow, and the heat resistance of the envelope surface is not good, there are burnt marks in the seal part. The maintenance method is to accelerate, cool and replace the film.

6. The air pressure is different. When the cylinder is loose, the heating temperature is low, and the hot roller and the active roller are not parallel, the hot rod will be bad. Maintenance methods Adjust the parallelism and closely adjust the temperature and pressure.

Note: Before starting up, you must insert the induction aviation plug and tighten the screws. Do not use a metal lid or metal container, do not place it on a metal table, and do not press the start button. damage to the machine. Always touch the surface of the sensor head when working to check for overheating. If overheating is found, the cooling stops the heating action. There is high pressure in the pillow pad of the three-side sealing wet towel packaging machine, and the bottom plate is charged. Please pay attention to avoid personal danger during maintenance.